The different stages when the worm gear lifter is loaded

Produced by our factoryWorm screw liftThe high-speed shaft can work in both forward and reverse directions, and its speed should not exceed 1500 rpm.The working environment temperature of the worm gear screw elevator is 0℃-40℃. When the working environment temperature is lower than 0℃, it is necessary to warm the lubricating oil to 0℃ before starting.
Worm screw liftThe axis of the high-speed shaft and low-speed shaft must be concentric with the axis of the connecting part, and the error should not be greater than the allowable value of the coupling used.Before the installed worm gear screw lift is officially used, it is necessary to carry out a load test.The load test line is no-load operation, and the load is started when there is no fault.Divided into the following four stages:
The stage load is 25% of the extra load.
The second stage load is 50% of the additional load.
The third stage load is 75% of the additional load.

The fourth stage load is the extra load.
The oil temperature during each stage of operation should not exceed 80 degrees Celsius. When it exceeds, it should be stopped immediately to check and determine the cause.