Installation of sprockets and chains during mechanical equipment installation

 When mechanical equipment is installedSprocketWhat are the assembly requirements with the chain?

  XNUMX. It should be cleaned before assembly.

  2. The centerlines of the active sprocket and the passive sprocket should coincide, and the deviation should not be greater than 1000/XNUMX of the center distance of the two sprockets.

  60. When the working side of the chain is tightened, the sag f (see the figure below) of the non-working side should meet the design requirements.When there is no regulation and the angle α between the chain and the horizontal line is less than XNUMX°, the twoSprocketAdjust the center distance from 1% to 4.5% of L.