Analysis: The reason why the temperature of the cycloid reducer is too high

If the cycloid reducer is heated during use and the temperature is too high, generally speaking, it may be a problem with the eccentric bearing and there is a fault.Of course, this is only a general situation, and other factors should also be considered. For example, if the machine is newly purchased, there may be unreasonable parts in the assembly, and there may be problems.Of course, this knowledge is the first reflection to be formed in the mind after the temperature failure of the reducer is found, but this does not mean that the problem is caused by this reason.For the temperature problem of the cycloid reducer, there may be another important factor to consider, that is, the problem of lubricating oil. If the reducer lacks lubricating oil, the above problems may also exist.This requires to prescribe the right medicine and adapt measures to local conditions.
Of course, there are some other reasons that need to be considered. If the cycloidal pinwheel reducer is often overloaded, it may also cause the temperature to be too high. However, these factors need to be continuously analyzed and eliminated to find the most correct answer.The reason why the temperature of the cycloid reducer is too high has been found, and then there are solutions. There are many solutions to things, but the most direct and simplest, and the most reasonable, should be the best method, which belongs to deceleration. The basic theory of machine technology will not be stated too much here.

In short, for the problem of excessively high temperature in the cycloid reducer, first find out the reasons for it, such as the above-mentioned possibilities. If these reasons are ruled out, then look for other factors that may affect the temperature of the reducer. Factors, and then prescribe the right medicine, give solutions, and implement them.Doing this makes it easy to deal with reducer failures.