Correct installation, use and maintenance of the reducer is to ensure that the mechanical equipment

In the past few years, when some users used the reducer, due to human factors such as illegal installation, the output shaft of the reducer was broken, causing the enterprise to suffer unnecessary losses.When installing the planetary reducer, please be sure to assemble and use carefully in strict accordance with the following installation and use related matters.

Step XNUMX: Confirm the motor andReducerWhether it is intact, and strictly check whether the dimensions of the parts connected to the motor and the reducer match, here are the dimensions and matching tolerances of the positioning boss of the motor, the input shaft and the groove of the reducer.

Step XNUMX: Unscrew the screw on the dust-proof hole on the outer side of the reducer flange, adjust the PCS system clamping ring to align the side hole with the dust-proof hole, and insert the inner hexagon to tighten.After that, remove the motor shaft key.

Step XNUMX: Connect the motor and the reducer naturally.When connecting, it must be ensured that the concentricity of the output shaft of the reducer and the input shaft of the motor is the same, and the outer flanges of the two are parallel.If the center is inconsistent, it will cause the motor shaft to break or the gear of the reducer to wear.

In addition, during installation, it is strictly forbidden to hit with a hammer, etc., to prevent excessive axial or radial force from damaging the bearings or gears.Be sure to tighten the mounting bolts before tightening the tightening bolts.Before installation, wipe off the anti-rust oil on the motor input shaft, positioning boss and the connection part of the reducer with gasoline or zinc-sodium water.Its purpose is to ensure the tightness of the connection and the flexibility of operation, and to prevent unnecessary wear.

Before connecting the motor to the reducer, the keyway of the motor shaft should be perpendicular to the tightening bolt.To ensure uniform force, first screw on the mounting bolts at any diagonal position, but do not tighten, then screw on the other two diagonal mounting bolts and finally tighten the four mounting bolts one by one.Finally, tighten the tightening bolts.All tightening bolts need to be fixed and checked with a torque wrench according to the marked fixed torque data.The correct installation between the reducer and mechanical equipment is similar to the correct installation between the reducer and the drive motor.The key is to ensure that the output shaft of the reducer is consistent with the concentricity of the driven part of the shaft.