Reducer model selection

There are several points to pay attention to when selecting the reducer model:
  The output shaft diameter of the reducer should not be larger than the used shaft diameter on the table.
  If the torque calculation works, the speed can meet the normal operation, but when the servo is fully output, if there is a shortage, we can do current limiting control on the driver on the motor side, or do torque protection on the mechanical shaft, which is very important. necessary.
  The selection of general reducer includes steps such as proposing original conditions, selecting types, and determining specifications.
  In contrast, the type selection is relatively simple, while accurately providing the working conditions of the reducer, and mastering the design, manufacture and use characteristics of the reducer are the keys to the correct and reasonable selection of the specifications of the general reducer.
  The selection of specifications should meet the conditions of strength, thermal balance, and radial load on the shaft extension.