Through the analysis of the power structure of the reducer, it can be seen that no matter what type of reducer, if the equipment wants to achieve the ideal transmission effect and have a longer service life, the installation of the equipment must be rigorous and standardized.For the worm gear reducer, it should be kept horizontal during the entire installation process, and in the actual installation process, all six sides should be able to be installed, but there are not too many requirements for the installation form.There are many types of reducers available on the market now, and the range of choices is relatively large, but try not to choose a coupling device with fixed connection steel. Even if such equipment is installed and standardized, it will inevitably cause bearing damage and breakage in use. Problems, if coupled with improper installation and other factors, the use effect is difficult to guarantee.
While the worm gear reducer is installed horizontally, it should also be noted that the oil in the oil tank should be drained clean.Pay attention to each component during the installation process to ensure reliability and firmness to prevent various problems due to loose components during the operation of the equipment.In addition, in the process of installing the reducer, pay attention to the strict matching of the structure of the equipment and the original equipment to ensure the alignment, and the error between them cannot exceed the compensation of the equipment.After the installation of the equipment is completed, further verification and debugging should be carried out, such as rotating the equipment by hand, to ensure that the equipment rotates flexibly and does not appear to be stuck.
If problems such as vibration, leakage, noise, etc. occur during the calibration and debugging process, they must be repaired and eliminated in time.According to the experience of the worm gear reducer during the installation process, if the equipment is not firmly fixed during the installation process, problems such as vibration and noise will occur and cause damage to the equipment.In general, if the equipment is to have a better operating effect, the installation process must be cautious and meticulous, and the prone to faults must be correctly prevented and checked.