What problems should be paid attention to when using cycloid reducer?

1. When the cycloid reducer uses the sprocket for transmission, do not put the tooth chain too loose, otherwise there will be an impact force when starting.

2. When connecting the couplings, gears, sprockets and other couplings of the cycloid reducer to the output shaft of the cycloid reducer, the method of direct hammering shall not be used, and the bolts should be screwed into the screw holes of the shaft extension end, and the pressure plate should be used to screw the bolts. push into.

3. The installed cycloid reducer must be tested before it is officially used.When the no-load operation is normal, gradually load the operation.